The manufacturer’s record · Page 8 of 8

2019 GMC YUKON XL
Manufacturer communications & TSBs.Page 8

Original record summaries, dates and identifiers for this model-year. Records 701–707 of 707, ordered newest first. Dated records on this page: Sep 10, 2018–Oct 9, 2018.

Back to 2019 GMC YUKON XL problems & recalls
Read the applicability before drawing a conclusion.

This archive includes service bulletins, warranty notices, software instructions and other communications. Records may repeat or supersede earlier instructions. A model-year association is not proof that a document covers every engine, trim, VIN or reported symptom, or that a repair is free.

NHTSA download snapshot: Sep 28, 2026. These are communication associations for this vehicle, not unique defects. How records are joined and counted.

Oct 9, 2018Service Bulletin/Repair Instructions

PIP5491A

NHTSA communication ID: 10147362

NHTSA source summary · Original PDF not reviewed by Recallfolio

This Preliminary information communicates to the technician when diagnosing intermittent circuit concerns to look at the connector for missing weather pack seals that could allow water intrusion into the connector and lead to corrosion on the terminals.

Source components: ELECTRICAL SYSTEM · STRUCTURE.

Source record 10147362 at NHTSA
Oct 4, 2018Service Bulletin/Repair Instructions

PIP5570A

NHTSA communication ID: 10147352

NHTSA source summary · Original PDF not reviewed by Recallfolio

This Preliminary information communicates to the dealer a conditionwhere a tick noise may be present inside a vehicle while driving. This may be the result of a deformed or improperly seated steering shaft seal allowing engine compartment sounds into the vehicle. Dealers are instructed to replace or reinstall the boot as needed and are informed the condition is being reviewed by engineering.

Source components: STEERING:GEAR BOX:SHAFT PITMAN · STEERING:GEAR BOX:SHAFT SECTOR.

Source record 10147352 at NHTSA
Oct 1, 2018Service Bulletin/Repair Instructions

PIT5604A

NHTSA communication ID: 10147342

NHTSA source summary · Original PDF not reviewed by Recallfolio

This Preliminary information communicates if the liftglass will not open using keyless entry to verify Valet Mode is not enabled.

Source components: STRUCTURE:BODY:HATCHBACK/LIFTGATE · STRUCTURE:BODY:HATCHBACK/LIFTGATE:SUPPORT DEVICE/STRUT.

Source record 10147342 at NHTSA
Sep 19, 2018Service Bulletin/Repair Instructions

PIT4322J

NHTSA communication ID: 10145500

NHTSA source summary · Original PDF not reviewed by Recallfolio

This Preliminary Information communication provides information to the technician about vehicles that have an unwanted Stability Activation and/or a Service Stability message on the Driver Information Center. Technician may find a Diagnostic Trouble Code C0710. Technician should inspect for vehicles modifications before any in-depth diagnostics are performed.

Source components: ELECTRONIC STABILITY CONTROL (ESC).

Source record 10145500 at NHTSA
Sep 13, 2018Service Bulletin/Repair Instructions

PIT5361D

NHTSA communication ID: 10145479

NHTSA source summary · Original PDF not reviewed by Recallfolio

This Preliminary Information communication provides information to the technician on the steps to diagnose and repair vehicles that may have issues were the customer will need increased effort to depress the brake pedal. Technician may find fluid in the brake booster and/or the booster vacuum line. Technician will need to replace Vacuum Pump, Brake Booster, Master Cylinder, Vacuum Pump Belt and the Vacuum Line between the booster and the pump.

Source components: SERVICE BRAKES.

Source record 10145479 at NHTSA
Sep 10, 2018Service Bulletin/Repair Instructions

PIT5448D

NHTSA communication ID: 10145470

NHTSA source summary · Original PDF not reviewed by Recallfolio

This Preliminary Information communication advises the technician with a tip when the vehicle stops running after it has been idling for 2.5 hours. This is normal operation of the vehicle built with regular production code BTM and without Regular Production Option Code AVF. If the vehicle was built with regular production code BTM and AVF only has a 1 hour idle time.

Source components: ENGINE AND ENGINE COOLING.

Source record 10145470 at NHTSA
Sep 10, 2018Service Bulletin/Repair Instructions

PIT5241F

NHTSA communication ID: 10145469

NHTSA source summary · Original PDF not reviewed by Recallfolio

This Preliminary Information communication provides information to the technician about customers that may request the factory Integrated Trailer Brake Controller Regular Production Option Code (JL1) be installed on their Full-Size Pickup or SUV when the vehicle was not ordered with the option. Dealer should advise the customer it cannot be added to the vehicle.

Source components: TRAILER HITCHES.

Source record 10145469 at NHTSA