Original record summaries, dates and identifiers for this model-year. Records 401–443 of 443, ordered newest first. Dated records on this page: Dec 13, 2012–Jun 23, 2017.
Read the applicability before drawing a conclusion.
This archive includes service bulletins, warranty notices, software instructions and other communications. Records may repeat or supersede earlier instructions. A model-year association is not proof that a document covers every engine, trim, VIN or reported symptom, or that a repair is free.
NHTSA download snapshot: Sep 28, 2026. These are communication associations for this vehicle, not unique defects. How records are joined and counted.
Jun 23, 2017Service Bulletin/Repair Instructions
11-174-17R
NHTSA communication ID: 10117535
NHTSA source summary · Original PDF not reviewed by Recallfolio
This bulletin announces the availability of reprogramming files to optimize the ECM and address the following customer concerns: * Check Engine light coming on (with DTC P05A0 stored in memory). * Potential battery discharge (dead battery) after repeated periods of short-trip driving. * A high (or "hanging") engine RPM after depressing the clutch pedal (Forester only).
Source components: ELECTRICAL SYSTEM · ELECTRICAL SYSTEM:12V/24V/48V BATTERY.
NHTSA source summary · Original PDF not reviewed by Recallfolio
Models with SRVD Only. This bulletin provides revised diagnostic and repair procedures to address DTC B2327 for the Subaru Rear Vehicle Detection (SRVD), Blind-Spot Detection (BSD) and Rear Cross Traffic Alert (RCTA) system on the applicable models listed above. Under very specific (rare) conditions, the radar function of the SRVD system may experience a communication error and cause the SRVD warning lamp to illuminate. In addition, under certain highway driving conditions, an improper signal calculation by the system may cause a Cancel Code B2328 to set which will also cause the SRVD warning lamp to illuminate.
NHTSA source summary · Original PDF not reviewed by Recallfolio
This bulletin announces the availability of reprogramming files to optimize the ECM and address the following customer concerns: * Engine RPM surge on light acceleration caused by improper EGR operation * Potential battery discharge (dead battery) after repeated periods of short-trip driving.
NHTSA source summary · Original PDF not reviewed by Recallfolio
This bulletin announces availability of ECM reprogramming files designed to optimize the ECM for improving HVAC blower fan speed control. There have been a limited number of cases with reports describing the blower fan speed fluctuating / changing without input from the customer when the blower is set to maximum speed.
Source components: ELECTRICAL SYSTEM · EQUIPMENT:APPLIANCE:AIR CONDITIONER.
NHTSA source summary · Original PDF not reviewed by Recallfolio
This Service Information bulletin announces a material change to the engine accessory drive / v-belt made to address customer concerns of a slipping belt (squeal or chirping) sound.
Source components: ENGINE · ENGINE AND ENGINE COOLING:ENGINE:GASOLINE:BELTS AND ASSOCIATED PULLEYS.
NHTSA source summary · Original PDF not reviewed by Recallfolio
This bulletin announces availability of a new steering wheel designed to address a possible customer concern of insufficient performance of the heated steering wheel feature on applicable models.
NHTSA source summary · Original PDF not reviewed by Recallfolio
ONLY 2016-2017MY: Those Models equipped with STARLINK Telematics. Provisioning is the process by which the DCM receives the subscription request and activates the related DCM features requested as outlined in the specific subscription contract. If provisioning is not successful then the DCM may remain in an inactive state and the requested services may not be activated for the customer. Field investigation has found that this may be a result of three possible conditions. * The DCM may be off the network due to vehicle storage or other network factors. * The DCM may be lacking power or ground due to some body side electrical concern. * The DCM may have an internal failure.
NHTSA source summary · Original PDF not reviewed by Recallfolio
This bulletin has been developed in response to a small number of customer concerns regarding fluid seepage found coming from the CVT assembly. Investigation has identified a likely source of the seepage to be the sealant used on the CVT's oil pump chain cover. The repair involves removal, a thorough cleaning and inspection of the sealing surfaces followed by re-sealing the cover.
Source components: POWER TRAIN · POWER TRAIN:AUTOMATIC TRANSMISSION.
NHTSA source summary · Original PDF not reviewed by Recallfolio
This bulletin announces new reprogramming file availability and the software installation procedure to address additional operational concerns received from the field and listed below involving "Gen 2" F10 Navigation and Display Audio units with 7" display. The procedure will involve downloading the applicable software update files from Subarunet then loading them onto a flash drive for audio unit installation. It is important to read through and understand this information completely before proceeding. These latest software updates contain new logic to address the following concerns: * Mirrorlink 1.1 updates * Enable Mute function for Navigation guidance * Incomplete display of intersection names in combination meter * Increased accuracy of the XM Traffic information displayed * Intermittent delay (approximately 1 minute) in display of map information after initial start-up of Navigation function (2015MY Legacy and Outback only).
NHTSA source summary · Original PDF not reviewed by Recallfolio
This bulletin outlines design changes made to the upper oil pan assembly on FA and FB engines used on the models listed above. There have been isolated cases where the sealer used between the upper oil pan and the crankcase has become displaced resulting in engine oil seepage.
NHTSA source summary · Original PDF not reviewed by Recallfolio
This bulletin contains illustrations of exchange components and their manufacturer as well as a description of the proper exchange procedure. The exchange program policy can also be found in Sections 8.4.9 and 11.2.10 of your Claims Policies and Procedures Manual found in Subarunet. CONTENTS Within the terms of the Basic New Car Warranty and the one year Replacement Parts Warranty, the Exchange Program provides for replacement of a defective unit from the manufacturer.
NHTSA source summary · Original PDF not reviewed by Recallfolio
REVISED. This bulletin announces a design change of the fuel injector used on 2.0L DIT models to prevent water intrusion. A new silicone rubber cover has been developed and incorporated into production for this purpose.
NHTSA source summary · Original PDF not reviewed by Recallfolio
This bulletin announces a design change of the fuel injector used on 2.0L DIT models to prevent water intrusion. A new silicone rubber cover has been developed and incorporated into production for this purpose.
NHTSA source summary · Original PDF not reviewed by Recallfolio
This Service Information bulletin announces a change to the shape of the rubber cap used on the flange nuts securing the sub-level sending unit to the fuel tank. In addition, two of the caps are now used in production instead of only one. This change was made to enhance productivity during vehicle assembly.
NHTSA source summary · Original PDF not reviewed by Recallfolio
Only Models Equipped with TR690 CVT only. This bulletin has been developed in response to a small number of customer concerns regarding fluid seepage found coming from the CVT assembly. Investigation has identified a likely source of the seepage to be the sealant used on the CVT's oil pump chain cover. The repair involves removal, a thorough cleaning and inspection of the sealing surfaces followed by re-sealing the cover.
Source components: POWER TRAIN · POWER TRAIN:AUTOMATIC TRANSMISSION.
NHTSA source summary · Original PDF not reviewed by Recallfolio
This bulletin announces new reprogramming file availability and the software installation procedure to address additional operational concerns received from the field and listed below involving ?Gen 2? F10 Navigation and Display Audio units with 7? display. The procedure will involve downloading the applicable software update files from Subarunet then loading them onto a flash drive for audio unit installation. It is important to read through and understand this information completely before proceeding. These latest software updates contain new logic to address the following concerns: ? Mirrorlink 1.1 updates ? Enable Mute function for Navigation guidance ? Incomplete display of intersection names in combination meter ? Increased accuracy of the XM Traffic information displayed ? Intermittent delay (approximately 1 minute) in display of map information after initial start-up of Navigation function (2015MY Legacy and Outback only).
NHTSA source summary · Original PDF not reviewed by Recallfolio
Turbo models only. This bulletin announces the availability of reprogramming files to optimize the ECM. These new files will address customer concerns of: ? Spark knock (ping) during high intake air temperature operation ? Surge on acceleration due to phantom knock detection ? Check Engine light illumination resulting from DTC P2270 and / or DTC P2270 and / or P0137 being stored in the ECM memory.
Source components: ELECTRICAL SYSTEM · ENGINE AND ENGINE COOLING:ENGINE:GASOLINE:TURBO/SUPERCHARGER.
NHTSA source summary · Original PDF not reviewed by Recallfolio
This bulletin announces the availability of reprogramming files to optimize the ECM. These new files will address customer concerns of Check Engine light illumination resulting from DTC P013F or P014B* being stored in the ECM memory. *DTC P014B is applicable to 3.6L models only.
NHTSA source summary · Original PDF not reviewed by Recallfolio
This bulletin announces a design change to the front speaker grille. The new grilles have increased retention capabilities to address customer concerns of a loose fit.
NHTSA source summary · Original PDF not reviewed by Recallfolio
This bulletin contains illustrations of exchange components and their manufacturer as well as a description of the proper exchange procedure. The exchange program policy can also be found in Sections 8.4.9 and 11.2.10 of your Claims Policies and Procedures Manual found in Subarunet.
NHTSA source summary · Original PDF not reviewed by Recallfolio
This announcement supersedes the announcement previously posted August 30, 2016. In the interest of customer satisfaction, Subaru of America, Inc. is initiating a service program for certain 2017 model year Forester non?Turbo vehicles with CVT. Description: The CVT fluid in affected vehicles was not filled to the proper specified level at the factory. The condition could cause a noticeable air vacuum noise or possibly even chain slip under high levels of shock load depending upon driving conditions (i.e. rapid acceleration or hill climbing). Extended driving under this low?fill condition is not recommended.
NHTSA source summary · Original PDF not reviewed by Recallfolio
(non-Turbo) with CVT. Subaru of America, Inc. (Subaru) is initiating a Service Campaign for certain 2017 model year Forester normally aspirated vehicles with CVT transmissions. Subaru has determined vehicles affected by this Service Program require additional CVT fluid. The CVT fluid (CVTFII) in affected vehicles was not filled to the proper specified level at the factory. The condition could cause a noticeable air vacuum noise or possibly even chain slip under high levels of shock load depending upon driving conditions (i.e. rapid acceleration or hill climbing). Extended driving under this low-fill condition is not recommended.
NHTSA source summary · Original PDF not reviewed by Recallfolio
This Bulletin provides information regarding DTC P0606 related specifically to the determination of this code on Forester Turbo and applicable WRX models. The engine management system is equipped with a back-up memory. When disconnecting the battery cables, this back-up memory is cleared. On Forester Turbo and applicable WRX models, after re-connecting the battery, if the ignition switch is turned back ?ON? within one minute after the first time the ignition is turned ?OFF?, it becomes possible for the CEL to illuminate storing DTC P0606 in memory. The code will not occur immediately, but may occur after a period of time depending upon how the vehicle is operated.
NHTSA source summary · Original PDF not reviewed by Recallfolio
NON-TURBO MODELS - Subaru of America, Inc. (Subaru) has determined that certain 2017 model year Forester normally aspirated vehicles equipped with CVT transmissions will require additional CVT fluid. The CVT fluid (CVTFII) in affected vehicles was not filled to the proper specified level at the factory. The condition could cause a noticeable air vacuum noise or possibly even chain slip under high levels of shock load depending upon driving conditions (i.e. rapid acceleration or hill climbing).
NHTSA source summary · Original PDF not reviewed by Recallfolio
The CVT fluid in affected vehicles was not filled to the proper specified level at the factory. The condition could cause a noticeable air vacuum noise or possibly even chain slip under high levels of shock load depending upon driving conditions (i.e. rapid acceleration or hill climbing). Extended driving under this low-fill condition is not recommended.
Source components: POWER TRAIN:AUTOMATIC TRANSMISSION.
NHTSA source summary · Original PDF not reviewed by Recallfolio
This Service Information bulletin provides a procedure to use when installing a SOA821B200 replacement battery in a 2015MY WRX (2.0L). The sensor located on the battery ground terminal interferes with the battery vent cap used on the replacement battery.
NHTSA source summary · Original PDF not reviewed by Recallfolio
Various paint manufacturers designate their own stock numbers and coding information although many of the major suppliers are now using the SOA paint codes to help eliminate possible confusion. Their color formulations are updated on a continual basis. Some vendors may have different color names than those provided to them by SOA. Be sure to double-check the codes and formulas beforehand to help insure an accurate color match. Should discrepancies arise, please refer your Body Shop contact inquiries to the specific paint vendor or their jobber/supplier for the most updated formula information.
NHTSA source summary · Original PDF not reviewed by Recallfolio
The purpose of this bulletin is to provide a description of current changes to Service Manuals available via the Subaru Technical Information System (STIS) web site. The tables contained within this bulletin are to be used as guides for becoming aware of the latest changes. We advise you to always refer to the STIS web site when looking for the latest Service information. Printed pages will not be made available to update printed Service Manuals.
NHTSA source summary · Original PDF not reviewed by Recallfolio
This Service Information bulletin provides new inspection and repair procedures for AVCS (Active Valve Control System) -related DTCs on the FA and FB engine equipped models listed above. The applicable Service Manuals will be revised with this new information in the near future.
NHTSA source summary · Original PDF not reviewed by Recallfolio
This Service Information bulletin provides a guideline to use for placement of required or mandated windshield stickers (inside and / or outside) on vehicles equipped with EyeSight Driver Assist Technology and High Beam Assist (HBA) features. Examples of these types of stickers include: * Government facility / Military base access stickers * State-mandated Vehicle Safety Inspection and Emission Compliance stickers * Parking Permit Stickers The cameras used by both of these features require a clear, unobstructed "view" through the windshield for their proper operation. The illustration below shows the "Prohibited area" in gray. Any stickers mandated to be placed within the Prohibited area should be placed to the right of the EyeSight stereo camera and HBA camera, outside of the Prohibited area as shown in the illustration below. Viewed from inside the vehicle, the left edge of the sticker must be placed no more than 14 inches (slightly less is preferred as a "cushion" for measuring variation) from the right edge of the windshield as shown in the illustration and indicated by the box outlined in blue. Always consult state and local regulations applicable to windshield sticker placement.
NHTSA source summary · Original PDF not reviewed by Recallfolio
This bulletin provides information to help diagnose and address different conditions relating to customer concerns which may arise when operating the new-generation ?Gen 2? and ?Gen 2.1? F10 Navigation and Display Audio systems.
NHTSA source summary · Original PDF not reviewed by Recallfolio
This Bulletin provides production change, repair procedure and parts information to address a customer concern of a high-pitched sound coming from the transmission extension housing area.