The manufacturer’s record · Page 2 of 2
Original record summaries, dates and identifiers for this model-year. Records 101–118 of 118, ordered newest first. Dated records on this page: Sep 1, 2007–Mar 1, 2013.
Back to 2007 BMW 335I problems & recallsThis archive includes service bulletins, warranty notices, software instructions and other communications. Records may repeat or supersede earlier instructions. A model-year association is not proof that a document covers every engine, trim, VIN or reported symptom, or that a repair is free.
NHTSA download snapshot: Sep 28, 2026. These are communication associations for this vehicle, not unique defects. How records are joined and counted.
NHTSA communication ID: 10150130
NHTSA source summary · Original PDF not reviewed by Recallfolio
The vehicle position is missing or incorrect on the navigation map. The navigation system integrated in the Car Information Computer (CIC) is not calibrated correctly.
Source components: EQUIPMENT · EQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM).
Source record 10150130 at NHTSANHTSA communication ID: 10150100
NHTSA source summary · Original PDF not reviewed by Recallfolio
The customer may complain that during the cold start in the morning, the engine runs very roughly and the Service Engine Soon lamp is illuminated. Various misfire fault codes (e.g., 29CC, 29D2, 29D1, 29D0, 29C0, 29CF) may be stored in the DME control module. The engine rough running complaint can be reproduced on a cold start in the workshop. During the course of diagnosis, the spark plugs, removed from the misfiring cylinders after the problem was reproduced, are found to be soaked (?wet?) with fuel, while the injector tips are covered with a layer of carbon deposit.
Source components: ENGINE · FUEL SYSTEM, GASOLINE.
Source record 10150100 at NHTSANHTSA communication ID: 10150099
NHTSA source summary · Original PDF not reviewed by Recallfolio
N54 Engine: Fuel Pressure Control Test Plan Error. INFORMATION Not applicable.
Source components: FUEL/PROPULSION SYSTEM.
Source record 10150099 at NHTSANHTSA communication ID: 10150096
NHTSA source summary · Original PDF not reviewed by Recallfolio
N55 Engine Failsafe - FC 120308 Boost Pressure Control, Plausibility: Pressure Too Low Stored in DME Fault Memory. INFORMATION The customer complains the SES is illuminated and the engine has reduced power (engine failsafe mode).
Source components: ENGINE · POWER TRAIN.
Source record 10150096 at NHTSANHTSA communication ID: 10038217
NHTSA source summary · Original PDF not reviewed by Recallfolio
BMW: CRANKCASE PRESSURE DIAGNOSIS AND INFORMATION FOR ALL VEHICLES. *RM UPDATED ON 4/24/2013. *KB
Source components: ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL:CRANKCASE (PCV).
Source record 10038217 at NHTSANHTSA communication ID: 10149441
NHTSA source summary · Original PDF not reviewed by Recallfolio
"Outside Door Mirror Moves when Locking or Unlocking the Vehicle. The door mirror tilts immediately after unlocking or locking. The mirror position does not correspond to the memory position preset by the customer. Pressing the seat memory button typically will return the mirror to the stored position. Poor electrical contacts of the mirror drive in the mirror housing INFORMATION The problem has been integrated into ISTA diagnostics. Complete the diagnosis test plan using the latest ISTA version. The test plan can be accessed via the following path: ""Information Search / Function Structure / Body / Mirror / Exterior mirrors / Driver's or passenger side / Electrochromic Mirror,"" and then press ""Start Search."" Select the test plan ""B5116_ECSPPL2."""
Source components: VISIBILITY.
Source record 10149441 at NHTSANHTSA communication ID: 10149431
NHTSA source summary · Original PDF not reviewed by Recallfolio
Erroneous Brake Pad Replacement Message. The Dynamic Stability Control module (DSC) calculates the brake pad replacement intervals based on information from the front and rear axle brake pad wear sensors. When replacement of the front and or rear brake pads is necessary, the DSC control module triggers an indicator lamp located in the vehicle's instrument cluster. However, the brake pad indicator lamp may be illuminated although a replacement of the brake pads is not necessary. Additionally, one or both of the following fault codes may be stored in the DSC control module: * 5DE0 Brake-pad wear: plausibility, front axle * 5DE1 Brake-pad wear: plausibility, rear axle CAUSE DSC software error
Source components: SERVICE BRAKES, HYDRAULIC.
Source record 10149431 at NHTSANHTSA communication ID: 10149429
NHTSA source summary · Original PDF not reviewed by Recallfolio
"N54 - Diagnosis of Cold Start Rough Running with Misfire Faults. The customer may complain that during the cold start in the morning, the engine runs very roughly and the Service Engine Soon lamp is illuminated. Various misfire fault codes (e.g., 29CC, 29D2, 29D1, 29D0, 29C0, 29CF) may be stored in the DME control module. The engine rough running complaint can be reproduced on a cold start in the workshop. During the course of diagnosis, the spark plugs, removed from the misfiring cylinders after the problem was reproduced, are found to be soaked (""wet"") with fuel, while the injector tips are covered with a layer of carbon deposit. Possible cause: high-pressure injector failure (leakage or incorrect spraying pattern) due to internal wear or unfavorable stock of tolerances IMPORTANT: For comprehensive N54 drivability diagnostics, always refer to the ""N54 Engine Diagnostic Fault Tree"" file (the current version ""02_14_13"" is found as a PDF attachment to SI B12 55 06)."
Source components: ENGINE AND ENGINE COOLING.
Source record 10149429 at NHTSANHTSA communication ID: 10150385
NHTSA source summary · Original PDF not reviewed by Recallfolio
"CCC - ""Please Insert Navigation DVD"" Appears on CID. The navigation map DVD cannot be read or detected. The message ""Please insert navigation DVD"" appears in the CID (Central Information Display). The navigation system is inoperative. This situation may also occur when upgrading to a new navigation map. The old map is recognized but the new one is not. CAUSE Faulty DVD drive; read error due to hardening of the anti-vibration gel on the read head"
Source components: EQUIPMENT.
Source record 10150385 at NHTSANHTSA communication ID: 10150381
NHTSA source summary · Original PDF not reviewed by Recallfolio
Junction Box Pin Assignment Change. When replacing the Junction Box (fuse box) using P/N 61 14 6 978 270 or later, note that various pin assignments have changed. The following additional work procedure is necessary to properly perform this repair.
Source components: ELECTRICAL SYSTEM.
Source record 10150381 at NHTSANHTSA communication ID: 10150330
NHTSA source summary · Original PDF not reviewed by Recallfolio
"Discharged Battery: Energy Diagnosis Must Be Performed. The electrical system of BMW vehicles has been subject to an ongoing development process over the last few years. This has led to increased demands being placed on the battery. This document covers important information for the dealer on how to handle ""discharged battery"" complaints. A discharged battery can have various causes, most of which do not concern the battery itself. A failed battery is often the symptom and not the cause. A fully serviceable battery fails when an electrical component causes the battery to discharge; the battery becomes internally damaged and must be replaced. For more information, refer to www.batteryuniversity.com/parttwo-42B.htm For this reason, replacing the battery is not usually a permanent repair. The cause of the discharged battery must be analyzed in order to guarantee a proper repair. In order to properly repair the vehicle the first time in the workshop, it is very important that the diagnostic test plans are performed to completion with all results taken into to consideration. The procedure as outlined below contains information that will guide the technician into properly repairing the vehicle and getting paid for a warranty claim. CAUSE Refer to the ""Procedure"" section of this Service Information for details."
Source components: ELECTRICAL SYSTEM.
Source record 10150330 at NHTSANHTSA communication ID: 10150329
NHTSA source summary · Original PDF not reviewed by Recallfolio
Intermittently the trunk lid does not pop open when using the remote, or latch when closing. If the vehicle is driven and the trunk is not closed fully, a Check Control message will be displayed in the instrument cluster. CAUSE The trunk lid is out of tolerance. When opening or closing the trunk lid, the latch rubs against the striker because of insufficient clearance.
Source components: EQUIPMENT.
Source record 10150329 at NHTSANHTSA communication ID: 10150324
NHTSA source summary · Original PDF not reviewed by Recallfolio
?SI B51 15 08 Body Equipment October 2012 Technical Service. This Service Information bulletin supersedes SI B51 15 08 dated July 2008. designates changes to this revision SUBJECT Rear Window False Anti-trap Activation. INFORMATION The anti-trap protection feature may be activated when no obstruction is present. This may occur at either one or both of the rear windows. The root cause of the false anti-trap activation may be difficult to determine. The attached diagnosis flowchart has been developed to assist with determining the actual root cause of the failure as well as to help prevent unnecessary part replacements. The root cause is typically either an issue with the window system, or an electrical/software issue. The diagnosis flowchart will help ensure that repairs are only carried out for the system that is most likely at fault. Refer to B511508_Attachment. PARTS INFORMATION Refer to the Electronic Parts Catalog (EPC) for the appropriate parts noted in the diagnostic flowchart. WARRANTY INFORMATION Not applicable.
Source components: VISIBILITY:GLASS, SIDE/REAR.
Source record 10150324 at NHTSANHTSA communication ID: 10033085
NHTSA source summary · Original PDF not reviewed by Recallfolio
BMW: COMPLAINT OF A DELAYED ENGAGEMENT AND A HARSH JOLT WHEN ACCELERATING FROM A STOP. THE SITUATION OCCURS ONLY DURING THE ENGINE WARM UP PHASE (COLD ENGINE), AND CANNOT BE REPRODUCED IN THE SPORT MODE. EGS SOFTWARE-UNFAVORABLE NIC CALIBRATION. *PE UPDATED 9/28/11. *PE
Source components: ELECTRICAL SYSTEM:SOFTWARE · ENGINE AND ENGINE COOLING:ENGINE · ENGINE AND ENGINE COOLING:ENGINE:DIESEL.
Source record 10033085 at NHTSANHTSA communication ID: 10037025
NHTSA source summary · Original PDF not reviewed by Recallfolio
BMW: PROCEDURE FOR DETERMINING AND REPLACING INCANDESCENT AND HALOGEN LIGHT BULBS UNDER WARRANTY. *RM
Source components: EXTERIOR LIGHTING.
Source record 10037025 at NHTSANHTSA communication ID: 10036979
NHTSA source summary · Original PDF not reviewed by Recallfolio
BMW: A NEW TECHNICAL PROCESS HAS BEEN CREATED FOR BMW TO IDENTIFY CAUSES OF STEERING COMPLAINTS WITH A WIDE RANGE OF MODELS. *RM
Source components: STEERING:ELECTRIC POWER ASSIST SYSTEM · STEERING:HYDRAULIC POWER ASSIST SYSTEM.
Source record 10036979 at NHTSANHTSA communication ID: 10033130
NHTSA source summary · Original PDF not reviewed by Recallfolio
BMW VEHICLES: FUEL LEVEL SENSOR REPAIRS. WHERE IT IS NECESSARY TO REPLACE THE RIGHT OR THE LEFT SIDE FUEL LEVEL SENSOR DUE TO A FAILURE, THE ENTIRE PUMP AND HOUSING OR DELIVERY UNIT (SUCTION JET ASSEMBLY) DO NOT NEED TO BE REPLACED AS WELL. IN SOME CASES, EPC DOES NOT SHOW THAT THE REPAIR KIT IS AVAILABLE SEPARATELY IN THE ILLUSTRATION, BUT IT IS AVAILABLE IN THE PARTS DESCRIPTION. ALL MODELS. NO MODEL YEARS LISTED. *PE
Source components: FUEL SYSTEM, GASOLINE:DELIVERY:FUEL PUMP.
Source record 10033130 at NHTSANHTSA communication ID: 10026984
NHTSA source summary · Original PDF not reviewed by Recallfolio
BMW: SERVICE ACTION: REPROGRAM THE CONTROL MODULE FOR THE TIRE PRESSURE MONITORING SYSTEM (RDC) AT EACH OF THE FOUR WHEELS ON MODELS E90, E91, E92, AND E93 (3 SERIES). *PE
Source components: TIRES:PRESSURE MONITORING AND REGULATING SYSTEMS.
Source record 10026984 at NHTSA